CM11 Clothing Monitor

CM11 Clothing Monitor

STS 806 Simulator

Quote 

 The STS CM11 Clothing Monitor Simulator consists of a real Thermo CM11 housing STS electronics and cable connector so that it will operate with a simulated STS probe - in this case a DP11 or DP6 style large area probe.

This probe detects the gas given off by the STS simulant, which has been applied to the surface to be monitored. This “radiation” may be detected by passing the probe close to and slowly over the surface, as would be done with a real probe when used by a skilled operator. Too fast, or too far away results in no detection – excellent training!

The DP11/DP6  houses 2 detectors which enables quicker and more accurate detection of the simulated contaminant.  The probe runs directly from the CM11s own power supply and like a real probe turns itself on when the instrument is switched on.

Cross contamination can easily be demonstrated to Nuclear industry trainees, as can decontamination – both benefits of using a “real” contamination, even if not radioactive.
The contamination lasts at room temperature for 1-2 hours but totally evaporates within 24hrs leaving the training area ready for the next exercise.

The CM11 is  particularly suited to power stations & nuclear fuel processors with a large through put of workers.

STS manufacture a wide range of simulators for many manufacturers products. We are happy to consider your specific requirements.
 

Back

Get A Quote